Juniper SRX110

About This Guide
This preface includes the following topics:
•
Objectives on page xi
•
Audience on page xi
•
Documentation Conventions on page xi
•
SRX Series Documentation and Release Notes on page xiii
•
Obtaining Documentation on page xiii
•
Documentation Feedback on page xiv
•
Requesting Technical Support on page xiv
Objectives
This guide describes hardware components and installation, basic configuration, and
basic troubleshooting procedures for the Juniper Networks SRX110 Services Gateway. It
explains how to prepare your site for services gateway installation, unpack and install
the hardware, power on the services gateway, perform initial software configuration, and
perform routine maintenance. After completing the installation and basic configuration
procedures covered in this guide, see the Junos OS software configuration guides for
information about further Junos OS software configuration.
Audience
This guide is designed for network administrators who are installing and maintaining a
Juniper Networks SRX110 Services Gateway or preparing a site for device installation. To
use this guide, you need a broad understanding of networks in general and the Internet
in particular, networking principles, and network configuration. Any detailed discussion
of these concepts is beyond the scope of this guide.
Documentation Conventions
Table 1 on page xii defines the notice icons used in this guide.
xiCopyright © 2013, Juniper Networks, Inc.