Juniper SRX110 Hardware Guide

CHAPTER 14
Performing Initial Software Configuration
on the SRX110 Services Gateway
This chapter includes the following topics:
•
SRX110 Services Gateway Software Configuration Overview on page 83
•
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
CLI on page 86
•
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
J-Web Interface on page 88
•
SRX110 Services Gateway Secure Web Access Overview on page 92
SRX110 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX110 Services Gateway for Configuration on page 83
•
Understanding Built-In Ethernet Ports on page 84
•
Understanding Management Access on page 85
Preparing the SRX110 Services Gateway for Configuration
When the device powers on, it tries to boot Junos OS from the default storage medium.
If the device fails to boot from the default storage medium, it tries to boot from the
alternate storage medium.
Table 35 on page 83 provides information on the storage media available on the services
gateway.
Table 35: Storage Media on the Services Gateway
TypeStorage Media
Default; always presentCompactFlash
AlternateUSB storage device
83Copyright © 2013, Juniper Networks, Inc.

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing