Juniper SRX110 Hardware Guide

CHAPTER 11
Connecting, Grounding, and Powering On
the SRX110 Services Gateway
This chapter includes the following topics:
•
Connecting the SRX110 Services Gateway to the Power Supply on page 67
•
Connecting and Organizing the SRX110 Services Gateway Interface Cables on page 68
•
Grounding the SRX110 Services Gateway on page 69
•
Powering On and Powering Off the SRX110 Services Gateway on page 71
Connecting the SRX110 Services Gateway to the Power Supply
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE: If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
1. Plug the DC connector end of the power cable into the power connector on the back
of the device (see Figure 23 on page 68).
2. Plug the AC adapter end of the power cable into an AC power outlet.
67Copyright © 2013, Juniper Networks, Inc.

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing