Table 40: SRX110 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Alarm
SeverityActionAlarm ConditionComponent
Amber
(minor)
•
If the internal flash memory fails at
startup, the services gateway
automatically boots from the alternative
boot device (USB storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
•
Reformat the internal flash memory,
and install a bootable image. (See the
Initial Configuration for Security
Devices and the Monitoring and
Troubleshooting for Security
Devices.)
•
If you did not configure the services
gateway to boot from an alternative
boot device, contact Juniper Networks
Technical Assistance Center (JTAC).
See “Juniper Networks Technical
Assistance Center” on page 103.
The services gateway
boots from an alternate
boot device.
Boot media
Amber
(minor)
•
Check the room temperature. See
“SRX110 Services Gateway
Specifications” on page 7.
•
Check the airflow. See “General Site
Guidelines for Installing the SRX110
Services Gateway” on page 40.
The services gateway
chassis temperature or
chassis is too warm.
Hardware
components
on the
services
gateway
Red
(major)
The services gateway shuts down
automatically in 4 minutes.
The services gateway
temperature is too high,
either because of an
internal overheating
condition or because
the maximum
recommended room
temperature has been
exceeded.
Monitoring the SRX110 Services Gateway Power System
The LEDs on the services gateway enable you to determine the performance and
operation. The Power LED, located on the front panel of the services gateway, indicates
the different settings with respect to the power system.
Table 41 on page 102 describes different Power LED status settings and their corrective
actions.
101Copyright © 2013, Juniper Networks, Inc.
Chapter 16: Monitoring the SRX110 Services Gateway
To Next Page
Loading...
