Juniper SRX110 Hardware Guide

Table 39: Component LEDs on the Services Gateway
Possible Causes and
Corrective ActionsMeaningStateLED
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
GreenStatus LED
Normal condition. No action
is required.
•
The device is starting up.
•
The Reset Config button
is pressed.
Amber
Contact the Juniper
Networks Technical
Assistance Center (JTAC).
See “Juniper Networks
Technical Assistance
Center” on page 103.
Indicates an error in the
device.
Red
Normal condition. No action
is required.
Indicates that the device is
functioning normally.
Green
Alarm LED
A critical alarm indicates a
critical situation on the
gateway that requires
immediate action.
See “Monitoring the SRX110
Services Gateway Using
Chassis Alarm Conditions”
on page 100.
The device indicates a critical
alarm.
Red
A major alarm requires
monitoring or maintenance.
If left unchecked, it might
cause an interruption in
service or degradation in
performance.
See “Monitoring the SRX110
Services Gateway Using
Chassis Alarm Conditions”
on page 100.
The device indicates a major
alarm.
Amber
Normal condition. No action
is required.
The device is starting up.
NOTE: When the system is
up and running, if the Alarm
LED is off, it indicates that no
alarms are present on the
device.
Off
99Copyright © 2013, Juniper Networks, Inc.
Chapter 16: Monitoring the SRX110 Services Gateway

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing