EasyManuals Logo

Juniper SRX110 Hardware Guide

Juniper SRX110
168 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
servicepersonal med ett speciellt verktyg, s och nyckel, eller annan
säkerhetsanordning, och kontrolleras av den auktoritet som ansvarar för
området.
Preventing Electrostatic Discharge Damage to the Services Gateway
Many services gateway hardware components are sensitive to damage from static
electricity. Some components can be impaired by voltages as low as 30 V. You can easily
generate potentially damaging static voltages whenever you handle plastic or foam
packing material or if you move components across plastic or carpets. Observe the
following guidelines to minimize the potential for electrostatic discharge (ESD) damage,
which can cause intermittent or complete component failures:
Always use an ESD wrist strap or ankle strap, and verify that it is in direct contact with
your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of 1 to 10 Mohms.
When handling any component that is removed from the chassis, verify that the
equipment end of your ESD strap is attached to one of the ESD points on the chassis.
Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can damage components.
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag. If you are returning
a component, place it into an electrostatic bag before packing it. See
Figure 27 on page 112.
Figure 27: Placing a Component into an Electrostatic Bag
Copyright © 2013, Juniper Networks, Inc.112
SRX110 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX110

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper SRX110 and is the answer not in the manual?

Juniper SRX110 Specifications

General IconGeneral
Memory1 GB
Flash1 GB
Operating Temperature32°F to 104°F (0°C to 40°C)
Interfaces8 x 10/100/1000 Ethernet
Power SupplyAC 100-240V, 50-60 Hz
Humidity10% to 90% non-condensing

Related product manuals