Juniper SRX110 User Manual

Table 33: SRX110 Services Gateway Preinstallation Checklist for
Rack-Mount Installation (continued)
Additional InformationTask
Verify that you have the following parts available
in your rack-mounting kit for the SRX110 Services
Gateway:
•
Rack-mounting brackets
•
Mounting screws
•
Power supply adapter tray with screws
•
Adapter stopper bracket
“Adjusting the Power Supply Adapter Tray
for the SRX110 Services Gateway for
Rack-Mount Installation” on page 92
Adjust the power supply adapter tray.
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
Related
Documentation
Site Preparation Checklist for the SRX110 Services Gateway on page 35•
• Unpacking the SRX110 Services Gateway on page 81
• Clearance Requirements for Airflow and Hardware Maintenance of the SRX110 Services
Gateway on page 40
• Preparing the SRX110 Services Gateway for Desk-Mount Installation on page 86
• Preparing the SRX110 Services Gateway for Wall-Mount Installation on page 87
Preparing the SRX110 Services Gateway for Desk-Mount Installation
You can mount the services gateway on a desk or other level surface horizontally or
vertically. The four rubber feet attached to the chassis provide stability.
Table 34 on page 86 provides the list of tasks you need to perform before installing the
device.
Table 34: SRX110 Services Gateway Preinstallation Checklist for
Desk-Mount Installation
Additional InformationTask
“Site Preparation Checklist for the SRX110
Services Gateway” on page 35
Verify that the site meets the requirements.
“Clearance Requirements for Airflow and
Hardware Maintenance of the SRX110
Services Gateway” on page 40
Place the desk in its permanent location, allowing
adequate clearance for airflow and maintenance,
and secure it to the building structure.
Copyright © 2012, Juniper Networks, Inc.86
SRX110 Services Gateway Hardware

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing