Juniper SRX110 User Manual

• SRX110 Services Gateway Front Panel and Back Panel Views with 3G and Integrated
VDSL2 on page 9
• SRX110 Services Gateway LEDs on page 13
Resetting the SRX110 Services Gateway
The Reset Config button on the front panel of the services gateway can be used to remove
the current configuration and reset the device to the default (factory) configuration. The
button is recessed in the front panel to prevent it from being pressed accidentally.
NOTE: Pressing and holding the Reset Config button for 15 seconds or more
deletes all configurations on the device and loads and commits the default
(factory) configuration.
Related
Documentation
• Powering On the SRX110 Services Gateway on page 105
• Powering Off the SRX110 Services Gateway on page 105
• Connecting the SRX110 Services Gateway to the Power Supply on page 101
• Grounding the SRX110 Services Gateway on page 103
• Using the Reset Config Button on the SRX110 Services Gateway on page 145
• SRX110 Services Gateway Front Panel and Back Panel Views with 3G and Integrated
VDSL2 on page 9
• SRX110 Services Gateway LEDs on page 13
107Copyright © 2012, Juniper Networks, Inc.
Chapter 14: Connecting, Grounding, and Powering On the SRX110 Services Gateway

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing