Juniper SRX110

Table 7: SRX110 Services Gateway Back Panel Components (continued)
ComponentNumber
Lock3
Grounding point4
CompactFlash card5
Power supply unit6
Cable tie holder7
NOTE:
•
If there is any problem with the CompactFlash card, you must return the
services gateway for repair or replacement. For this, you need to contact
Juniper Networks Technical Assistance Center (JTAC).
•
The cable tie holder provides support for holding the power cord to the
power supply point.
•
The lock allows you to lock and secure the device to the installation site.
Related
Documentation
SRX110 Services Gateway Specifications on page 7•
• SRX110 Services Gateway Built-In Interfaces on page 11
• SRX110 Services Gateway LEDs on page 13
• SRX110 Services Gateway Power Supply on page 17
SRX110 Services Gateway Built-In Interfaces
Table 8 on page 12 summarizes the interface ports supported on the SRX110 Services
Gateway.
11Copyright © 2012, Juniper Networks, Inc.
Chapter 2: Hardware Components and Specifications