Juniper SRX110 User Manual

CHAPTER 14
Connecting, Grounding, and Powering On
the SRX110 Services Gateway
•
Connecting the SRX110 Services Gateway to the Power Supply on page 101
•
Connecting and Organizing the SRX110 Services Gateway Interface Cables on page 102
•
Grounding the SRX110 Services Gateway on page 103
•
Powering On the SRX110 Services Gateway on page 105
•
Powering Off the SRX110 Services Gateway on page 105
•
Resetting the SRX110 Services Gateway on page 107
Connecting the SRX110 Services Gateway to the Power Supply
To connect the device to the power supply:
CAUTION: Before connecting the device to the power supply, attach an ESD
strap to an ESD point and place the other end of the strap around your bare
wrist.
NOTE: If you are installing your services gateway on a desk, ensure that your
device is adequately grounded using the grounding point on the back panel
of the chassis.
1. Plug the DC connector end of the power cable into the power connector on the back
of the device (see Figure 26 on page 102).
2. Plug the AC adapter end of the power cable into an AC power outlet.
101Copyright © 2012, Juniper Networks, Inc.

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing