Juniper SRX110 User Manual

NOTE: You must manually configure the IP address for the management
port you are using before you save your initial configuration. When you save
the configuration for the firsttime, youwill losethe connection to the services
gateway if you have not manually configured the IP address. If you lose the
connection through the management interface, you must connect through
the Console port.
Related
Documentation
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
CLI on page 123
•
• Connecting the Services Gateway to the CLI Locally on page 115
• SRX110 Services Gateway Software Configuration Overview on page 121
• SRX110 Services Gateway Secure Web Access Overview on page 131
Connecting the Services Gateway to the CLI Locally
If you plan to use the command-line interface (CLI) to configure the SRX110 Services
Gateway, you must connect through the Console port, as shown in Figure 29 on page 115.
Figure 29: Connecting to the Console Port on an SRX110 Services Gateway
g033620
NOTE: Figure 29 on page 115 shows a connection to a local management
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 male to DB-25 male (or similar) adapter for your
modem, which you must purchase separately.
115Copyright © 2012, Juniper Networks, Inc.
Chapter 16: Establishing Basic Connectivity

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing