Juniper SRX110 User Manual

CHAPTER 17
Configuring Basic Settings
•
SRX110 Services Gateway Software Configuration Overview on page 121
•
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
CLI on page 123
•
Performing Initial Software Configuration on the SRX110 Services Gateway Using the
J-Web Interface on page 126
SRX110 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX110 Services Gateway for Configuration on page 121
•
Understanding Built-In Ethernet Ports on page 122
•
Understanding Management Access on page 122
Preparing the SRX110 Services Gateway for Configuration
When the device powers on, it tries to boot Junos OS from the default storage medium.
If the device fails to boot from the default storage medium, it tries to boot from the
alternate storage medium.
Table 43 on page 121 provides information on the storage media available on the services
gateway.
Table 43: Storage Media on the Services Gateway
TypeStorage Media
Default; always presentCompactFlash
AlternateUSB storage device
NOTE: The SRX Series devices that ship with Junos OS Release 10.0 or later
are formatted with dual-root partitions from the factory. SRX Series devices
that are running Junos OS Release 9.6 or earlier can be formatted with
dual-root partitions when they are upgraded to Junos OS Release 10.0 or
later.
121Copyright © 2012, Juniper Networks, Inc.

Juniper SRX110 Specifications

General

Memory	1 GB
Flash	1 GB
Operating Temperature	32°F to 104°F (0°C to 40°C)
Interfaces	8 x 10/100/1000 Ethernet
Power Supply	AC 100-240V, 50-60 Hz
Humidity	10% to 90% non-condensing