Juniper SRX345

CHAPTER 21
Overview of Replacing Components
•
SRX345 Services Gateway Field Replaceable Units Overview on page 97
•
Required Tools and Parts for Replacing the SRX345 Services Gateway
Components on page 97
SRX345 Services Gateway Field Replaceable Units Overview
Field-replaceable units (FRUs) are components that you can replace at your site. The
Mini-Physical Interface Module (MPIM) is the only FRU on the SRX345 Services Gateway.
The Mini-PIMs are not hot-swappable. You must power off the services gateway before
removing or installing Mini-PIMs.
Related
Documentation
Required Tools and Parts for Replacing the SRX345 Services Gateway Components
on page 97
•
• Replacing Mini-Physical Interface Modules in the SRX345 Services Gateway on page 99
Required Tools and Parts for Replacing the SRX345 Services Gateway Components
The following tools and parts are required for replacing a Mini-Physical Interface Module
(MPIM) on the services gateway:
•
Electrostatic bag or antistatic mat, for each component
•
Electrostatic discharge (ESD) grounding wrist strap
•
Flat-blade (–) screwdriver, approximately 1/8 in. (3 mm)
•
Phillips (+) screwdriver, number 1
•
Blank panels (if no component will be installed)
Related
Documentation
• SRX345 Services Gateway Field Replaceable Units Overview on page 97
• Replacing Mini-Physical Interface Modules in the SRX345 Services Gateway on page 99
97Copyright © 2017, Juniper Networks, Inc.