Juniper SRX345

CHAPTER 16
Connecting the SRX345 Services Gateway
to External Devices
•
Connecting the Dial-Up Modem to the Console Port on the SRX345 Services
Gateway on page 59
•
Connecting to the SRX345 Services Gateway CLI Using a Dial-Up Modem on page 60
Connecting the Dial-Up Modem to the Console Port on the SRX345 Services Gateway
To connect the dial-up modem to the console port on the services gateway:
1. Turn off power to the services gateway.
2. Turn off power to the modem.
3. Connect one end of the Ethernet cable supplied with your services gateway into the
console port on the services gateway.
4. Connect the other end of the CAT-5e cable (Ethernet cable) into the RJ-45 to DB-9
serial port adapter supplied with your services gateway.
5. Connect the serial port adapter to a separately purchased DB-9 female to DB-25
male adapter or other adapter appropriate for your modem.
6. Plug the modem adapter into the DB-25 connector on the modem.
7. Connect the modem to your telephone network.
8. Turn on the power to the modem.
9. Power on the services gateway by pressing the Power button on the front panel. Verify
that the PWR LED on the front panel turns green.
59Copyright © 2017, Juniper Networks, Inc.