Juniper SRX345

CHAPTER 18
Performing the Initial Configuration
•
SRX345 Services Gateway Software Configuration Overview on page 67
•
Understanding SRX345 Services Gateway Factory-Default Settings on page 68
•
Viewing SRX345 Services Gateway Factory-Default Settings on page 69
•
Configuring Zero-Touch Provisioning on the SRX345 Services Gateway on page 70
•
Accessing J-Web on the SRX345 Services Gateway on page 71
•
Configuring the SRX345 Services Gateway Using the J-Web Setup Wizard on page 72
•
Accessing the CLI on the SRX345 Services Gateway on page 76
•
Connecting to the SRX345 Services Gateway from the CLI Remotely on page 77
•
Configuring the SRX345 Services Gateway Using the CLI on page 78
SRX345 Services Gateway Software Configuration Overview
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled and ready to be configured when the device is powered on. You can
perform the initial software configuration of the services gateway by using any one of
the following:
•
Zero Touch Provisioning (ZTP)
•
Setup wizard
•
Command-line interface (CLI)
Starting with Junos OS Release 15.1X49-D100, ZTP is the default method for provisioning
the device. However, if you want to use the J-Web setup wizard, then instead of ZTP, you
can use the option provided in the client portal to skip to the J-Web setup wizard for
performing the initial software configuration of your device.
Related
Documentation
Understanding SRX345 Services Gateway Factory-Default Settings on page 68•
• Viewing SRX345 Services Gateway Factory-Default Settings on page 69
• Accessing J-Web on the SRX345 Services Gateway on page 71
• Configuring the SRX345 Services Gateway Using the J-Web Setup Wizard on page 72
• Accessing the CLI on the SRX345 Services Gateway on page 76
67Copyright © 2017, Juniper Networks, Inc.