Juniper SRX5400 - Services Processing Cards; Services Processing Cards Specifications; Services Processing Card SRX5 K-SPC-2-10-40 Specifications

CHAPTER 2
Services Processing Cards
IN THIS CHAPTER
Services Processing Cards Specicaons | 8
Services Processing Cards
Specicaons
IN THIS SECTION
Services Processing Card SRX5K-SPC-2-10-40 Specicaons | 8
Services Processing Card SRX5K-SPC-4-15-320 Specicaons | 14
Services Processing Card SRX5K-SPC3 Specicaons | 19
Services Processing Card SRX5K-SPC-2-10-40 Specicaons
The SRX5K-SPC-2-10-40 Services Processing Card (SPC) contains two Services Processing Units (SPUs),
which provide the processing power to run integrated services such as rewall, IPsec, and IDP (see
Figure 2 on page 9). All trac traversing the rewall is passed to an SPU to have services processing
applied to it. Trac is intelligently distributed by I/O cards (IOCs) to SPUs for services processing.
The rewall must have at least one SPC installed. You can install addional SPCs to increase services
processing capacity.
You can install SPCs in any of the slots that are not reserved for Switch Control Boards (SCBs). If a slot is
not occupied by a card, you must install a blank panel to shield the empty slot and to allow cooling air to
circulate properly through the device.
Figure 2 on page 9 shows a typical SPC supported on the rewall.
8