Juniper SRX5400 - Flex IO Card Port Module SRX-IOC-4 XGE-XFP Specifications

LEDs OK/FAIL LED, one bicolor:
• Steady green–The port module is operang normally.
• Red–The port module has failed and is not operang normally.
• O–The port module is powered down.
LINK LED, single color, one per port:
• Steady green–The link is acve.
•
O–No link.
TX/RX LED, single color, one per port:
•
Blinking green–The port is receiving or transming data.
•
O–No acvity.
Serial Number
Locaon
The serial number label is located as shown in Figure 16 on page 38.
Figure 16: Port Module SRX-IOC-16GE-TX Serial Number Label
Flex I/O Card Port Module SRX-IOC-4XGE-XFP Specicaons
You use port modules and Flex I/O Cards (Flex IOCs) to add dierent combinaons of small form-factor
pluggable transceiver (SFP), 10-gigabit SFP transceiver (XFP), and copper ports to your rewall to suit
the specic needs of your network. The SRX-IOC-4XGE-XFP port module (Figure 17 on page 39)
installs into a Flex IOC to add four 10-Gigabit Ethernet XFP ports.
38