Juniper SRX5400 - MIC with 20 X1 Ge SFP Interfaces (SRX-MIC-20 GE-SFP)

Supported slots
• SRX5400–Any slot except boom slot 0
• SRX5600–Any slot except boom slots 0 or 1
• SRX5800–Any slot except center slots 0 or 1
Power
requirement
Maximum of 570 W for the MPC with two MICs, including applicable transceivers.
NOTE:
• To install and use SRX5K-MPCs in the SRX5600 and SRX5800 Firewalls, you must have
high-capacity power supplies (either AC or DC) and high-capacity fan trays installed in
the rewalls. All models of SRX5400 Firewalls already include high-capacity supplies. If
you do not have high-capacity power supplies and fan trays installed, the rewall will log
an alarm condion when it recognizes the SRX5K-MPCs.
• On SRX5400 and SRX5600 Firewalls with AC power supplies, we recommend that you
use high-line (220 V) input power to ensure that the devices have adequate power to
support SRX5K-MPCs.
Weight Approximately 10 lb (4.5 kg) without MICs
LEDs OK/FAIL LED, one bicolor:
• Green–The MPC is operang normally.
• Blinking green–The MPC is transioning to online or oine.
• Red–The MPC has failed and is not operang normally.
• O–The MPC is powered down.
Serial number
locaon
The serial number label is yellow and is located on the opposite side of the card.
MIC with 20x1GE SFP Interfaces (SRX-MIC-20GE-SFP)
You use Modular Interface Cards (MICs) and Modular Port Concentrators (MPCs) to add dierent
combinaons of Ethernet interfaces to your rewall to suit the specic needs of your network.
The SRX-MIC-20GE-SFP MIC (see Figure 20 on page 45) can be installed in the SRX-5K MPC to add
twenty 1-Gigabit Ethernet small form-factor pluggable (SFP) Ethernet ports.
44