Juniper SRX5400 - Page 65

Soware features
• Opcal diagnoscs and related alarms
• Two packet-forwarding engines, PFE0 and PFE1. PFE0 hosts PIC0 and PIC2. PFE1 hosts
PIC1 and PIC3.
• Congurable LAN-PHY mode opons per 10-Gigabit Ethernet port
• Intelligent oversubscripon services
NOTE: At any one me you can have only one of the following PIC combinaons powered
on:
• PIC0 & PIC1
• PIC0 & PIC3
• PIC2 & PIC1
• PIC2 & PIC3
If you congure any of the following invalid PIC combinaons, the chassis will set PIC0 &
PIC1 combinaon online.
• PIC0 & PIC2
• PIC1 & PIC3
LEDs OK/FAIL LED, one bicolor:
• Solid green—MPC is funconing normally.
• Blinking green—MPC is transioning online or oine.
• Red—MPC has failed.
10-Gigabit Ethernet LINK LED, one green per port:
• Green—Link is up.
•
O—Link is down or disabled.
40-Gigabit Ethernet LINK LED, one bicolor per port:
•
Green—Link is up.
•
Amber—Link is disabled.
• O—Link is down.
61