Juniper SRX5400 - Page 67

NOTE: These cards do not support plug-in Modular Interface Cards (MICs).
All ports on the interface card have dual-color LEDs for reporng link status.
The interface card also supports hot-pluggable opcal modules.
Figure 32: SRX5K-MPC3-100G10G
If a slot in the SRX5400, SRX5600, or SRX5800 Firewall card cage is not occupied by a card, you must
install a blank panel to shield the empty slot and to allow cooling air to circulate properly through the
rewall.
Descripon
• Fixed-conguraon MPC with two 100-Gigabit Ethernet ports and four 10-Gigabit
Ethernet ports
• Maximum throughput: 240 Gbps
• Maximum congurable MTU: 9192 bytes
Soware release Junos OS Release 15.1X49-D10 and later
Supported Slots
• SRX5400 – Any slot, except the boom slot 0 which is reserved for SCB/RE.
• SRX5600 – Any slot, except the boom slots 0 or 1 which are reserved for SCB/RE.
• SRX5800 – Any slot, except the middle slots 0, 1, and 2/6 which are reserved for
SCB/RE and slots 0 (le most) and 11 (right most).
NOTE: You can use the 2/6 slot to install an interface card if an SCB is not already
installed in it.
Cables and
connectors
Sockets for 100-Gbps and 10-Gbps SFP+ transceivers
See Hardware Compability Tool for the transceivers supported.
63