Need help?Do you have a question about the Juniper SSG 140 and is the answer not in the manual?
General| Model | SSG 140 |
|---|---|
| Ports | 8 x 10/100 Ethernet |
| Power Supply | AC 120/230 V (50/60 Hz) |
| Weight | 8.5 lbs |
| Interfaces | 8 x 10/100 Ethernet, 2 x 10/100/1000 Ethernet |
| Operating Temperature | 0 °C to 40 °C |
| Storage Temperature | -20 °C to 70 °C |
| Humidity | 10% to 90% (non-condensing) |
| Product Series | SSG Series |
Details the location and function of the SSG 140's built-in ports and power connector.
Describes front panel elements: LEDs, ports, reset pinhole, and USB port.
Details back panel components: PIM slots, power switch, AC inlet, and fuse cover.
Covers pre-installation precautions and instructions for mounting the SSG 140 in an equipment rack.
Details connecting interface cables, AC power, and powering the device on/off.
Guides on connecting the SSG 140 to untrusted and trusted networks via various ports.
Details methods for accessing and managing the SSG 140: Console, WebUI, Telnet, and default settings.
Covers essential configurations: admin credentials, date/time, IP, DNS, hostname, and default route.
Explains configuration for PIMs: ISDN, T1, E1, and Serial WAN interfaces.
Details firewall policies, verifying connectivity, and device reset procedures.
Lists the necessary tools and parts for performing service and maintenance on the SSG 140.
Provides instructions for removing and installing Physical Interface Modules (PIMs).
Details upgrading memory and replacing the fuse on the SSG 140 device.
Lists physical dimensions, weight, electrical parameters, and environmental operating conditions.
Details safety, EMC, and telecommunications standards relevant to the SSG 140.
Provides detailed RJ-45 connector pinouts for the console and AUX ports.
Guides through Rapid Deployment, Admin Login, and interface/zone configuration.
Covers configuring interface IP addresses, DHCP, and final confirmation of settings.
To Next Page