Tools and Parts Required 43
Chapter 4
Servicing the Device
This chapter describes service and maintenance procedures for the SSG 140 device.
It includes the following topics:
“Tools and Parts Required” on this page
“Replacing a Physical Interface Module” on page 44
“Upgrading Memory” on page 46
“Replacing the Fuse” on page 48
Tools and Parts Required
To replace a component on an SSG 140 device, you need the following tools and
parts:
Electrostatic bag or antistatic mat
Electrostatic discharge grounding wrist strap
Flat tip screwdriver, 1/8 inch
Number-2 phillips screwdriver
NOTE: For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. The instructions in the guide warn you about situations that
could cause bodily injury. Before working on any equipment, you should be aware
of the hazards involved with electrical circuitry and should be familiar with
standard practices for preventing accidents.
To Next Page
Loading...