PIM Configuration 35
Default Route
The default route is a static route used to direct packets addressed to networks that
are not explicitly listed in the routing table. If a packet arrives at the device with an
address for which the device does not have routing information, the device sends
the packet to the destination specified by the default route.
To configure the default route on the device, use the WebUI or CLI as follows:
WebUI
Network > Routing > Destination > New (trust-vr): Enter the following, then
click OK:
IP Address/Netmask: 0.0.0.0/0.0.0.0
Next Hop
Gateway: (select)
Interface: ethernet0/0 (select)
Gateway IP Address: ip_addr
CLI
set route 0.0.0.0/0 interface ethernet0/0 gateway ip_addr
save
Ethernet0/0 Interface IP Address
You can change the default IP address of the ethernet0/0 interface to match
addresses that already exist on your Trusted LAN.
WebUI
Network > Interfaces > Edit (for ethernet0/0): Enter the following, then click
OK:
IP Address/Netmask: ip_addr/mask
CLI
set interface ethernet0/0 ip ip_addr/mask
save
PIM Configuration
This section explains how to configure the following physical interface modules
(PIMs):
ISDN Interface
T1 Interface
E1 Interface
Serial WAN Interface
To Next Page
Loading...