SSG 140 Series Hardware Installation and Configuration Guide
30 Default Device Settings
The WebUI application displays the login prompt as shown in Figure 12.
Figure 12: WebUI Login Prompt
4. If you have not yet changed the default login for the admin name and
password, enter
netscreen at both the admin name and password prompts.
(Use lowercase letters only. The login and password fields are both
case-sensitive.)
Using Telnet
To establish a Telnet connection, perform the following steps:
1. Connect your workstation to the 0/0 port (ethernet0/0 interface) on the device.
2. Ensure that your workstation is configured for DHCP or is statically configured
with an IP address in the 192.168.1.0/24 subnet.
3. Start a Telnet client application to the IP address for the ethernet0/0 interface
(the default IP address is 192.168.1.1). For example, enter
telnet 192.168.1.1.
The Telnet application displays the login prompt.
4. If you have not yet changed the default admin name and password, enter
netscreen at both the login and password prompts. (Use lowercase letters only.
The login and password fields are both case-sensitive.)
5. (Optional) By default, the console times out and terminates automatically after
10 minutes of idle time. To remove the timeout, enter
set console timeout 0.
Default Device Settings
This section describes the default settings and operation of an SSG 140 device.
Table 7 describes the default zone bindings for ports on the device.
The cable connections shown in Figure 10 on page 23 use the default settings of
some of the ports.
To Next Page
Loading...