SSG 140 Series Hardware Installation and Configuration Guide
38 PIM Configuration
set user “server” type wan
set user “server” password “server”
For information on how to configure the E1 interface, refer to the Concepts &
Examples ScreenOS Reference Guide.
Serial WAN Interface
Serial WAN links provide bidirectional links that require very few control signals. In
a basic serial setup, the data communications equipment (DCE) is responsible for
establishing, maintaining, and terminating a connection. A modem is a typical DCE
device. A serial cable connects the DCE to a telephony network where, ultimately, a
link is established with data terminal equipment (DTE). DTE is typically where a link
terminates.
SSG 140 series serial WAN PIMs support the following serial standards:
TIA/EIA 530
V.35
X.21
RS-232
RS-449
To configure serial interface characteristics, use the WebUI or CLI:
WebUI
Network > Interfaces > List > Edit (WAN Interface) > WAN: Select the following,
then click Apply:
DTE Options
Select your options
CLI
set interface interface serial-options dte-options { ... }
save
For more information on how to configure the ISDN interface, refer to the Concepts
& Examples ScreenOS Reference Guide.
To Next Page
Loading...