Back Panel 17
Table 6: Juniper Serial Cables
Power Switch
The power switch is located on the right side of the back panel, as shown in
Figure 7. You use the power switch to power the SSG 140 device on and off. When
you power on the device, ScreenOS boots up as the power supply completes its
startup sequence.
Figure 7: Power Switch, AC Power Appliance Inlet, and Fuse Cover
AC Power Appliance Inlet
The AC power appliance inlet is located on the right side of the back panel, as
shown in Figure 7. You use the AC power appliance inlet to connect the SSG 140
device to an AC power source using the supplied AC power cord.
Fuse Cover
The fuse cover is located on the right side of the back panel, as shown in Figure 7.
To change the fuse, see “Replacing the Fuse” on page 48.
Product Number Interface Type Length (in feet) Connector Type
JX-CBL-EIA530-DCE EIA 530 (DCE) 10 feet Female
JX-CBL-EIA530-DTE EIA 530 (DTE) 10 feet Male
JX-CBL-RS232-DCE RS-232 (DCE) 10 feet Female
JX-CBL-RS232-DTE RS-232 (DTE) 10 feet Male
JX-CBL-RS449-DCE RS-449 (DCE) 10 feet Female
JX-CBL-RS449-DTE RS-449 (DTE) 10 feet Male
JX-CBL-V35-DCE V.35 (DCE) 10 feet Female
JX-CBL-V35-DTE V.35 (DTE) 10 feet Male
JX-CBL-X21-DCE X.21 (DCE) 10 feet Female
JX-CBL-X21-DTE X.21 (DTE) 10 feet Male
Power
Switch
AC Power
Appliance Inlet
Fuse
Cover
To Next Page
Loading...