SSG 140 Series Hardware Installation and Configuration Guide
16 Back Panel
Figure 6: SSG 140 PIMs
Table 6 lists the cables that you can order from Juniper Networks to connect to a
port on the serial PIM. The device to which you are connecting and the serial
interface type determine which cable you need.
T1/E1 STATUS Green On steadily Online with no alarms or failures.
Red On steadily Active with a local alarm; device has detected a
failure.
Sync Serial STATUS Green On steadily Online with no alarms or failures.
Red On steadily Active with a local alarm; device has detected a
failure.
Type Name Color State Description
CAUTION: PIMs are not hot-swappable. You must install them in the back panel
slots before powering on the device.
ISDN
T1
E1
Synch Serial
To Next Page
Loading...