Juniper SSG 140 - Port and Power Connectors

SSG 140 Series Hardware Installation and Configuration Guide
10  Port and Power Connectors
Port and Power Connectors
This section describes and displays the location of the built-in ports and power
connector.
Figure 2: Built-in Ports and Power Connector Locations
Table 1: SSG 140 Ports and Power Connector
POWER HA PIM1 PIM3
STATUS ALARM PIM2 PIM4 RESET
CONSOLEUSB AUX 10/100 10/100/1000
0/0 0/1 0/2 0/3
TX/RX TX/RX TX/RX TX/RXLINK LINK LINK LINK
0/4 0/5 0/6 0/7
TX/RX TX/RX TX/RX TX/RXLINK LINK LINK LINK
0/8
TX/RX LINK
0/9
TX/RX LINK
SSG 140
USB Port
Console Port
AUX Port
10/100 Ethernet
Ports
10/100/1000
Ethernet Ports
Front
E1
PORT 0
STATUS
PORT 1
STATUS
E1
PORT 0
STATUS
PORT 1
STATUS
I
O
AC Power Appliance Inlet
Back
Port Description Connector Speed/Protocol
0/0-0/7 Enables direct connections to workstations or a LAN
connection through a switch or hub. This
connection also allows you to manage the device
through a Telnet session or the WebUI.
RJ-45 10/100 Mbps Ethernet
Autosensing duplex and auto MDI/MDIX
0/8-0/9 Enables direct connections to workstations or a LAN
connection through a switch or hub. This
connection also allows you to manage the device
through a Telnet session or the WebUI.
RJ-45 10/100/1000 Mbps Ethernet
Autosensing duplex and auto MDI/MDIX
USB Enables a 1.1 USB connection with the device. N/A 12M (full speed) or 1.5M (low speed)
Console Enables a serial connection with the device. Used
for terminal-emulation connectivity to launch CLI
sessions.
RJ-45 9600 bps/RS-232C serial
AUX Enables a backup RS-232 async serial Internet
connection through an external modem.
RJ-45 9600 bps — 115 Kbps/RS-232C serial
PIM
T1 Enables connection of a T1 line to the untrusted
network.
RJ-48 1.544 Mbps (full-time slots)
E1 Enables connection of an E1 line to the untrusted
network.
RJ-48 2.048 Mbps (full-time slots)
ISDN Enables connection of an ISDN line to the untrusted
network.
RJ-45 B-channels at 64 Kbps
Leased line at 128 Kbps
Serial Provides full-duplex, synchronous data transmission
over serial links.
DB-60 8 Mbps
Power
AC Power
appliance inlet
Accepts the supplied AC power cord. N/A 90-264 VAC 50-60 Hz