19
Chapter 2
Installing and Connecting the Device
This chapter describes how to install an SSG 140 device in a standard 19-inch
equipment rack and how to connect cables and power to the device. Topics in this
chapter include:
“Before You Begin” on page 20
“Equipment Installation” on page 20
“Connecting Interface Cables to the Device” on page 22
“Connecting AC Power to the Device” on page 22
“Powering the Device On and Off” on page 22
“Connecting the Device to a Network” on page 23
NOTE: For safety warnings and instructions, please refer to the Juniper Networks Security
Products Safety Guide. Before working on any equipment, you should be aware of
the hazards involved with electrical circuitry and should be familiar with standard
practices for preventing accidents.
To Next Page
Loading...