JVC LT-Z37DX5 - Page 12

1-12 (No.YA362)
3.1.10 REMOVING THE SPEAKER (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 6 screws [A], then remove the SPEAKER (L /R).
NOTE:
• Since the speaker is attached in a certain direction, attach
the speaker in the same correct direction as it has been
attached.
• When the speaker is decomposed, the performance cannot
be kept.
3.1.11 REMOVING THE FRONT LED PWB (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the FAN BRACKET.
(1) Remove the 2 screws [B], then remove the FRONT LED
PWB.
3.1.12 REMOVING THE LED LENS (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the FAN BRACKET.
• Remove the FRONT LED PWB.
(1) Remove the 2 screws [C], then remove the LED LENS.
3.1.13 REMOVING THE CARD PWB (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the CARD SHIELD.
(2) Remove the 4 screws [D], then remove the CARD PWB.
3.1.14 REMOVING THE LCD PANEL UNIT (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the FAN BRACKET.
(1) Remove the 2 screws [E], then remove the CARD BASE.
(2) Remove the 2 screws [F], then remove the CARD PWB
BRACKET.
(3) Remove the 2 screws [G], then remove the MAIN BASE.
(4) Remove the 3 screws [H], the 2 screws [J] and the 1 screw
[K], then remove the TOP FRAME.
(5) Remove the 2 screws [L] and the 2 screws [M], then
remove the BOTTOM FRAME.
(6) Remove the LCD PANEL UNIT from the FRONT PANEL.
NOTE:
• Pay special attention not to break or damage on the FRONT
PANEL.
• The LCD PANEL UNIT is fixed to the FRONT PAMEL (at the
back side)by using double-side adhesive tapes. To remove
the LCD PANEL UNIT, remove the adhesive tape on the
FRONT PANEL slowly.