Operation
8 --- 31
8.6 Acknowledgement of Service Messages
When maintenance is due the yellow LED (15) on SIGMA CONTROL flashes.
Before any maintenance is due an initial warning is displayed to allow
coordination of service and maintenance personnel and provision of
necessary servicing materials. (lubricants, spare parts, etc.).
Maintenance due is shown in the display (12).
A list of service messages that may occur during operation is included in the SIGMA
CONTROL service manual.
Carry out the maintenance work.
Acknowledge service message with the reset key (11) --- LED (15) extinguishes.
When the respective maintenance has been carried out, the remaining
interval period (programmed interval until the next maintenance is due)
must be reset.
Detailed information on resetting service counters is to be found in the service manual for
SIGMA CONTROL.
Attention!
Attention!
To Next Page
Loading...
