Kamstrup flowIQ 3100 User Manual

flowIQ® 3100 TECHNICAL DESCRIPTION
31
Kastup A/S • Tehial Desiptio • 5512-1242_D1_GB • 09.2016
9.7.5 Adjustment mark
The sol A and the corresponding figure indicate the number of flow adjustments and legal changes
after factory verification. For further description see paragraph
Legal changes outside seal
It is possible to reset the legal registers and change the factory programmed flow curve to a limited extent.
The flow adjustment makes it possible to adjust the existing curve at three points. The total adjustment
compared to the factory adjustment cannot exceed +/- 10 %.
As long as o adjustets hae ee ade, oth the A ad the digit ae iatie, ad Kastup A/S does
ot add futhe adjustet akig to the ete. Afte the fist adjustet, the A activates and the digit
shows the number of adjustments (1 to 9). Below you see the sequence from adjustments 1 to 9.

Kamstrup flowIQ 3100 Specifications

General

Brand	Kamstrup
Model	flowIQ 3100
Category	Measuring Instruments
Language	English