13
ANTRIEBSTECHNIK
1
113
05.01.99
KEB COMBIVERT F4-C
Name:Basis
1
Introduction
General
© KEB Antriebstechnik, 1997
All Rights reserved
Chapter
Section
Page
Date
Who shall read all this?
Everybody who is entrusted with the development and construction of applications.
He who knows the extensive programming possibilities of the COMBIVERT, can
save external controls and expensive cabling already in the planning stage of a
machine simply by using the unit as active control element. This manual is not a
replacement of the documentation accompanying the unit, it serves only as
completion.
1000 and one application...
and if possible with one unit. Who does not know this demand from purchasing
departments, production or service. We have taken this request very seriously
and developed a series with open programming, which can be adapted to the
different applications with PC, chipcard or manually.
Nobody can handle this...
some sceptics may say. But we have found a solution to this too. Once the
development stage of a machine is completed only a few adjustment possibilities
are needed on the inverter and in some cases even none at all. So why should all
parameters still be visible? Said and done, by defining an own menu only selected
parameters are visible. This makes the handling much easier, simplifies the user
documentation and improves the safety of operation against unauthorized access
(see picture 1.1.2).
1.1.2 Preface
Picture 1.1.2
Entire parameter pool
User menu
(CP-Parameters)
To Next Page
Loading...
Need help?
General