KEB COMBIVERT F4-C - Functional Description; Encoder Interface with 2 Nd Encoder................................. 6

ANTRIEBSTECHNIK
610 1
KEB COMBIVERT F4-C
Name: Basis
19.11.98
KEB COMBIVERT F4-C
ANTRIEBSTECHNIK
Functional Description
Chapter
Section
Page
Date
© KEB Antriebstechnik, 1997
All Rights reserved
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Applications
13. Annex
6.1 Operating and Appliance
Displays
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage/Frequency (U/f)
Characteristics
6.6 Motor Presetting
6.7 Keep on Running Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 PI-Controller
6.12 CP-Parameter definition
6.10.1 Encoder summary ................. 3
6.10.2 Encoder interface with 2nd
encoder.................................. 4
6.10.3 Encoder interface with tacho
generator evaluation .............. 6
6.10.4 Encoderinterface with ±10V
input....................................... 6
6.10.5 Encoder interface with initiator
input....................................... 6
6.10.6 Speed measurement ............. 7
6.10.7 Evaluation of incremental
encoders................................ 8
6.10.8 Evaluation of tacho generators9
6.10.9 Evaluation of initiators.......... 10
6.10.10 Gearbox factors ................... 10
6.10.11 Error message E.co1/E.co2. 10
6.10.12 Definition of actual value
channel (cn.3) ................. 10
6.10.13 Frequent errors .................... 11
6.10.14 Used parameters ................. 11