KEB COMBIVERT F5 BASIC - Page 10

1 1
Name:Basis
KEB COMBIVERT F5-G / B
10
28.02.02
Introduction
General
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter Section Page Date
6.4.8 Limiter (oP.36...41) ............................................................. 6.4.15
6.4.9 Ramp with constant time ................................................... 6.4.15
6.4.10 Used Parameters............................................................... 6.4.18
6.5 Voltage-/Frequency Characteristic Adjustment............................... 6.5.3
6.5.1 Control Type (ud.2) and Max Frequency Mode (only F5-B).. 6.5.3
6.5.2 Rated frequency (uF.0) and Boost (uF.1) ............................. 6.5.4
6.5.3 Additional Rated Point (uF.2/uF.3) ....................................... 6.5.4
6.5.4 Delta Boost (uF.4/uF.5) ........................................................ 6.5.4
6.5.5 Voltage Stabilization (uF.9).................................................. 6.5.5
6.5.6 Maximal voltage mode (uF.10)............................................. 6.5.6
6.5.7 Switching Frequency (uF.11) ............................................... 6.5.6
6.5.8 Used Parameters................................................................. 6.5.7
6.6 Motor Data Adjustment ...................................................................... 6.6.3
6.6.1 Motor Name Plate................................................................ 6.6.3
6.6.2 Motor Data from the Name Plate (dr.0...dr.5) ........................ 6.6.3
6.6.3 Motor Data from Data Sheets (dr. 9)..................................... 6.6.4
6.6.4 Motor Stator Resistance (dr.6) ............................................. 6.6.4
6.6.5 Used Parameters................................................................. 6.6.6
6.7 Protective Functions.......................................................................... 6.7.3
6.7.1 Ramp Stop and Hardware Current Limit.............................. 6.7.3
6.7.2 Current Limit Constant Run (Stall-Function)........................ 6.7.5
6.7.3 Automatic Restart and Speed Search ................................. 6.7.7
6.7.4 Dead Time Compensation uF.18 ......................................... 6.7.9
6.7.5 Base-Block Time (uF.12) and Voltage Level (uF.13) ............ 6.7.9
6.7.6 Response to Errors or Warning Signal ................................ 6.7.9
6.7.7 Quick Stop (Pn.58...60) ..................................................... 6.7.13
6.7.8 Motor Protection Mode ...................................................... 6.7.15
6.7.9 GTR7-Control.................................................................... 6.7.19
6.7.10 Special Functions.............................................................. 6.7.20
6.8 Parameter Sets ................................................................................... 6.8.3
6.8.1 Not Programmable Parameters ........................................... 6.8.3
6.8.2 Security-Parameters ............................................................ 6.8.3
6.8.3 System-Parameters ............................................................. 6.8.3
6.8.4 Indirect and Direct Set Addressing ...................................... 6.8.3
6.8.5 Copying of Parameter Sets via Keyboard (Fr.1) ................... 6.8.4
6.8.6 Copying of Parameter Sets via Bus (Fr.1, Fr.9) .................... 6.8.4
6.8.7 Parameter Set Selection...................................................... 6.8.5
6.8.8 Locking of Parameter Sets................................................... 6.8.8
6.8.9 Parameter Set ON/Off Delay (Fr.5, Fr.6) ............................... 6.8.8
6.8.10 Used Parameters................................................................. 6.8.9
6.9 Special Functions .............................................................................. 6.9.3
6.9.1 DC-Braking ......................................................................... 6.9.3
6.9.2 Energy Saving Function ...................................................... 6.9.5
6.9.3 Motor Potentiometer Function.............................................. 6.9.7
6.9.4 Timer and Counter ............................................................ 6.9.11
6.9.5 Brake Control .................................................................... 6.9.15