KEB COMBIVERT F5 BASIC - Page 11

11
1
111
28.02.02
KEB COMBIVERT F5-G / B
Name:Basis
1
Introduction
General
© KEB Antriebstechnik, 2002
All Rights reserved
Chapter Section PageDate
6.9.6 Power-Off Function............................................................ 6.9.19
6.9.7 Wobbel Function ............................................................... 6.9.27
6.9.8 Diameter Correction .......................................................... 6.9.29
6.9.9 Positioning Function.......................................................... 6.9.31
6.9.10 Analog setting of parameter values ...................................6.9.34
6.10 Encoder Interface ............................................................................. 6.10.3
6.10.1 Designs ............................................................................. 6.10.3
6.10.2 Encoder Interface Channel 1 (X3A)................................... 6.10.4
6.10.3 Encoder Inteface Channel 2 (X3B) .................................... 6.10.5
6.10.4 Power Supply of Encoder .................................................. 6.10.7
6.10.5 Selection of Encoder ......................................................... 6.10.8
6.10.6 Basic Setting ................................................................... 6.10.10
6.10.7 Additional Parameters ..................................................... 6.10.13
6.10.8 Used Parameters............................................................. 6.10.14
6.11 SSM ................................................................................................... 6.11.3
6.11.1 Torque Compensation ....................................................... 6.11.3
6.11.2 Speed Control ................................................................... 6.11.4
6.11.3 Used Parameters............................................................... 6.11.6
6.12 Technology Controller ..................................................................... 6.12.3
6.12.1 The PID Controller ............................................................ 6.12.3
6.12.2 PID Setpoint Value ............................................................ 6.12.5
6.12.3 PID Actual Value ............................................................... 6.12.6
6.12.4 Sample Applications ......................................................... 6.12.7
6.12.5 Used Parameters............................................................. 6.12.10
6.13 CP-Parameter Definition .................................................................. 6.13.3
6.13.1 Survey ............................................................................... 6.13.3
6.13.2 Assignment of CP-Parameters .......................................... 6.13.4
6.13.3 Example ............................................................................ 6.13.5
6.13.4 Display Standardization .................................................... 6.13.6
6.13.5 Used Parameters............................................................... 6.13.8
7. Start-up .......................................................................................................... 7.1.3
7.1 Preparatory Measures........................................................................ 7.1.3
7.1.1 After unpacking the Goods .................................................. 7.1.3
7.1.2 Installation and Connection................................................. 7.1.3
7.1.3 Checklist prior to Start-up .................................................... 7.1.4
8. Special Operations................................................................................ 8.1.2
9. Error Assistance.................................................................................... 9.1.3
9.1 Troubleshooting ................................................................................. 9.1.3
9.1.1 General ............................................................................... 9.1.3
9.1.2 Error Messages and their Cause ......................................... 9.1.3
10. Project Planning .................................................................................. 10.1.3
10.1 General Design ................................................................................. 10.1.3
10.1.1 Control Cabinet Design Calculation .................................. 10.1.3
10.1.2 Design of Braking Resistors .............................................. 10.1.4
10.1.3 Cable and Fuses ............................................................... 10.1.6