KEB COMBIVERT F5 BASIC - Page 102

6 1
Name: Basis
KEB COMBIVERT F5-G / B
16
24.06.02
Functional Description
© KEB Antriebstechnik, 2002
All rights reserved
Chapter Section Page Date
Operating and Appliance Data
Adr.
min max
default
022Dh
ru.45 Actual switching frequency
1
-
-
40
Shows the current switching frequency of the inverter. The displayed value corresponds to following switching frequencies:
0=2kHz 3=12kHz
1=4kHz 4=16kHz
2=8kHz
Adr.
min max
default
022Ch
ru.44 Timer 2 / display
0.01
s / h
-
655.350
The count of the free-programmable timer 2 is indicated. The display is done either in seconds, in hours or in slopes/100
(see LE.26). The counter can be adjusted to any chosen value by keyboard or bus. The programming of the counter is
done with the parameters LE.22...LE.26 (also see Chapt. 6.9.4 „Timer“).
Adr.
min max
default
0234h
ru.52 External PID out display
0,1
%
-
100,0-100,0
A universal PI-controller is integrated into the inverter. It can be used externally as well as internally. The indicated
manipulated variable is given out in a range of ±100 %.
Adr.
min max
default
0235h
ru.53 AUX display
0,1
%
-
400,0-400,0
The AUX input is setting with An.30. This parameter shows the value of the analog signal AUX in percent. The range of
indication is limited to ±400 % (also see Chapt. 6.2 „Analog inputs“).
Adr.
min max
default
022Eh
ru.46 Motor temperature (optionally)
1
°C
-
2550
Indicates the current motor temperature. Precondition for this function is aspecial power circuit. The temperature detection
is connected to the terminals T1/T2.
0: T1/T2 closed 253, 254: broken cable; short circuit; detection error
255: T1/T2 open
This parameter shows the rated DC-link voltage automatically determined by the inverter. The value is measured at
switch-on.
Adr.
min max
default
0244h
ru.68 Rated DC voltage
1
V
-
10000