KEB COMBIVERT F5 BASIC - Page 247

Functional Description
1. Introduction
2. Summary
3. Hardware
4. Operation
5. Parameter
6. Functions
7. Start-up
8. Special Operation
9. Error Assistance
10. Project Planning
11. Networks
12. Annex
6.1 Operating and Applicance
Date
6.2 Analog In- and Outputs
6.3 Digital In- and Outputs
6.4 Set Value and Ramp
Adjustment
6.5 Voltage-/Frequency
Characteristic (U/f)
Adjustment
6.6 Motor Data Adjustment
6.7 Protective Functions
6.8 Parameter Sets
6.9 Special Functions
6.10 Encoder Interface
6.11 SMM
6.12 Technology Control
6.13 CP-Parameter Definition
6
10 1
KEB COMBIVERT F5
Name: Basis
28.01.02
Section PageDate
© KEB Antriebstechnik, 2002
All rights reserved
Chapter
6.10.1 Designs .................................. 3
6.10.2 Encoder Interface Channel 1 .. 4
6.10.3 Encoder Interface Channel 2... 5
6.10.4 Power Supply of Encoder........ 7
6.10.5 Selection of Encoder .............. 8
6.10.6 Basic Settings ...................... 10
6.10.7 Additional Parameters ........... 13
6.10.8 Used Parameters .................. 14