KEB COMBIVERT F5-H - Speed Measurement

Page 7.11 - 2 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Speed measurement
7.11.2 Encoder interface channel 1 (X3A) ....................................................................................... 7.11 - 4
7.11.2.1 TTL incremental encoder input (standard at F5-M) .............................................7.11 - 4
7.11.2.2 Resolver evaluation (standard at F5-S) ............................................................... 7.11 - 5
7.11.3 Encoder interface channel 2 (X3B) ....................................................................................... 7.11 - 6
7.11.3.1 Incremental encoder input ................................................................................... 7.11 - 6
7.11.3.2 Incremental encoder output ................................................................................. 7.11 - 7
7.11.4 Voltage supply of the encoder .............................................................................................. 7.11 - 8
7.11.5 Selection of encoder .............................................................................................................. 7.11 - 9
7.11.6 Encoderidentier................................................................................................................. 7.11 - 10
7.11.7 Initial setting ......................................................................................................................... 7.11 - 11
7.11.8 Gear factor ............................................................................................................................ 7.11 - 14
7.11.8.1 Denition ............................................................................................................ 7.11 - 14
7.11.8.2 Gear factor / analog setting ............................................................................... 7.11 - 16
7.11.8.3 Gear factor / set-programming........................................................................... 7.11 - 16
7.11.9 Emulation mode ................................................................................................................... 7.11 - 17
7.11.10 Absolute position (encoder 1) ............................................................................ 7.11 - 18
7.11.10.1 Position values...................................................................................................7.11 - 18
7.11.10.2 System offset .....................................................................................................7.11 - 18
7.11.10.3 Absolute position (encoder 1) ............................................................................ 7.11 - 19
7.11.11 Further parameters / encoder ............................................................................................. 7.11 - 19
7.11.11.1 SSI encoder at channel 1 .................................................................................. 7.11 - 19
7.11.11.2 SSI encoder at channel 2 .................................................................................. 7.11 - 19
7.11.11.3 SSI position standardization channel 1 and 2 (Ec.41) ....................................... 7.11 - 20
7.11.11.4 Tachometer at channel 2 ................................................................................... 7.11 - 21
7.11.11.5 Evaluation intelligent interface ........................................................................... 7.11 - 21
7.11.11.6 Encoder over gear (ec.39) ................................................................................. 7.11 - 25
7.11.11.7 Consider deceleration times of the position sensing ......................................... 7.11 - 25