Need help?Do you have a question about the KEB COMBIVERT H6 Series and is the answer not in the manual?
General| Series | H6 |
|---|---|
| Category | Control Unit |
| Input Voltage | 3-phase, 380-480V AC |
| Output Voltage | 0-480V AC |
| Control Mode | V/f control, vector control |
| Protection Features | Overcurrent, overvoltage, undervoltage, overload, short circuit, overtemperature |
| Communication Interfaces | RS485, CANopen, Profibus, Ethernet |
| Cooling Method | Fan cooling |
| Ambient Temperature | -10°C to +40°C |
| Storage Temperature | -25°C to +70°C |
| Relative Humidity | 5-95% (non-condensing) |
| Altitude | Up to 1000 m |
| Enclosure Rating | IP20 |
Instructions for safe installation, including environmental and mounting considerations.
Crucial safety procedures for connecting the device electrically to prevent hazards.
Safety precautions for starting, operating, and handling the device during use.
Defines the intended application and prohibits misuse of the drive system.
Details electrical operating conditions and device classification.
Comprehensive technical specifications for AIC modules across different sizes.
Detailed technical data for the H6 charging modules.
Guidelines and distances for installing the device in a control cabinet.
Details the terminal connections on the front side of the device.
Shows rear connections for device sizes C and S, including terminal details.
Shows rear connections for device sizes E and U, including terminal details.
Shows rear connections for device sizes G and W, including terminal details.
Details digital inputs/outputs and communication interfaces on the upper side.
Detailed assignment and connection data for terminal blocks X1E and X1F.
Details connections for the power unit terminal strip X1A on the rear.
Details connections for the braking resistor (X1B) and protective earth (PE).
Instructions for connecting the DC bus between H6 devices using copper bars.
Instructions for connecting the 24V bus for control and power supply.
Diagram showing the wiring of filter, AIC, and charging modules.
Wiring diagram for connecting filter, AIC, charging module, and control to the DC bus.
Explains the error chain connection for module communication and fault reporting.
Details for connecting to the EtherCAT system bus for communication.
Information on using the RS232/485 interface for diagnostics and service tools.
How to connect the control release for power module voltage supply.
Essential initial settings required before operating the drive converter.
A detailed flowchart for the step-by-step start-up of the H6 AIC.
To Next Page
