KEB COMBIVERT F5-H - Start-Up F5 E-S (SCL)

Page 6.2 - 18 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Start-up
11. Adjustmentofspecicdata
⇒ dS.02 current decoupling = 1 : on
⇒ uF.15 hardw. curr. lim. mode = 0: off
Overload characteristic of the motor:
⇒ dr.33 DSM max. torque (otherwise 5* dr27 rated tor-
que)
12. Optimize speed controller
See chapter 7.11 for all data of the adjustment
The start-up is successful completed if no error messages have arisen.
A detailed parameter description and their effects are described in chapter 7.6.
6.2.2.2 Start-up F5E-S (SCL)
The following steps describe a standard start-up when using a KEB motor or "customer-specic motor“. An
encoder feedback is not used.
1. Open control release
deactivate terminal X2A.16
⇒ ru.00 inverter state = nop/ „no control release“
2. Selection of the speed range
The usable speed range is adjusted with Ud.02:
⇒ Ud.02 control type = 8…11
See chapter 5.1 for all data of the adjustment
3. Loading the default parameters
⇒ Fr.01 copy parameter set = - 4
4. Select source of the speed feedback
⇒ cS.01 actual source = 2 : calculated actual value
5. Input of the motor rating plate data
⇒ dr.23 DSM rated current
⇒ dr.24 DSM rated speed
⇒ dr.25 DSM rated frequency
⇒ dr.26 dr.26 DSM EMC [Vpk*1000RPM]
[Vpk x 1000rpm] *
⇒ dr.27 DSM rated torque
⇒ dr.28 DSM curr. f. zero speed
⇒ dr.30 DSM winding resistance *
⇒ dr.31 DSM winding inductance *
* Note:
dr.30 and dr.31 must be entered as phase-
phase value (RUV, LUV).
Equivalent circuit data must be entered
according to the data sheet OR the data
must be identied automatically like step 7.
dr.26 must be programmed as peak value of
the phase-phase voltage UUV.
6. Calculation of motor-dependent data
⇒ Fr.10 load motor-dep. parameter = 2: act. DC link
voltage