30
60
90
120
150
180
210
240
270
300
0 105 110 115 120 125 130 135 140 145 150 160 170 180 190 200
210 220
IN / %
t / s
Figure 2: Overload characteristic
On exceeding a load of 105% the overload integrator starts. When falling below the
integrator counts backwards. If the integrator achieves the overload characteristic that
corresponds to the drive converter, „ERROR overload“ is triggered
After a cooling period the message „no ERROR overload“ is displayed. The error can
be reset now. The drive converter must remain switched on during the cooling period.
30
TECHNICAL DATA G6 400V CLASS
To Next Page
Loading...
Need help?
General