31
Table of ContentsSetting Up the LSXUsing the KEF Control AppPlayback and StreamingFAQ and Troubleshooting
8.1.3 Adjusting the Settings of the Speakers
Tap the Speaker Settings icon ( ) at the top right corner on the home screen to access
the settings menu for more configurations.
• Cable Mode
You can connect the Master and Slave Speakers with the provided inter-speaker cable
through the “To Master/Slave” connection ports on the back of the speakers.
Once the cable is connected, enable Cable Mode to disable the wireless connection.
Cable Mode is required/recommended when:
• You are performing a firmware update.
• You prefer a better resolution at 96 kHz/24 bit (wireless: 48 kHz/24 bit).
• You are experiencing audio dropouts due to interference.
• Inverse L/R Speakers
Enable this setting to change the master channel to the left (L) channel.
• Standby Mode
This determines how long (20 or 60 min) the speakers will remain idle before
automatically entering Standby Mode. If “never” is selected, the speakers must be
manually turned off.
To Next Page
Loading...
