KEF LSX - Operation Issues

58
Table of ContentsSetting Up the LSXUsing the KEF Control AppPlayback and StreamingFAQ and Troubleshooting
12.2 Operation
1. How can I turn on and turn o the speakers?
You can either use the physical remote control or the KEF Control app to power the
speakers ON or OFF.
On the physical remote control press the power button once to toggle between ON
and OFF.
On the KEF Control app from Standby press the desired source to power ON the
speaker. Press the active source icon to power OFF the speaker.
Note: Direct playback from Spotify Connect can also wake up the speaker.
2. How can I change input sources?
You can either use the physical remote control or the KEF Control app to switch
sources.
On the physical remote control press the source button once to toggle between
inputs.
On the KEF Control app press the source icon once to switch to a particular input. The
colour of each source corresponds to the colour of the LED on the Master Speaker.
3. How can I inverse the left and right speakers?
In the KEF Control app: navigate to Settings > Enable/disable Inverse L/R Speaker.
The status of the Master Speaker will change from RIGHT Channel (disabled) to LEFT
Channel (enabled).
4. What is Cable Mode?
Cable Mode disables the wireless pairing between Master and Slave Speakers.
Cable Mode is needed when:
1. You are performing a speaker firmware update.
2. You prefer listening to music at 96kHz/24bit.
• Wireless Mode: 48kHz/24bit
• Cable Mode: 96kHz/24bit
3. You are experiencing audio dropouts due to interference.