55
Table of ContentsSetting Up the LSXUsing the KEF Control AppPlayback and StreamingFAQ and Troubleshooting
5. How can I distinguish between the Left and Right speakers?
By default the Master will be the Right channel. It should be placed on the right hand
side of the speaker as you face it.
The Slave or Left channel should be placed on the left hand side of the speaker.
You can swap the channels inside the KEF Control app: Settings > Inverse L/R Speakers.
6. How far should I separate the Master and Slave speakers?
For the best stereo experience/soundstage, place the speakers 1 to 3 meters apart.
Maximum distances between the Master and Slave Speakers:
• Wireless Mode: Up to 5 meters, although interference from Wi-Fi and Bluetooth
can reduce this distance.
• Cable Mode: Up to 8 meters using a shielded Cat-6 Ethernet cable
7. What router should I use?
The default router from your Internet Service Provider usually comes with poor speed
and range. They are not recommended.
For better streaming stability, especially on Hi-Res music files, a 5GHz Wi-Fi network
with a router transmission speed of at least 1300Mbps is recommended.
Below are detailed technical requirements:
• Support IEEE 802.11a/b/g/n
• Use security protocol WPA2
Open networks are not recommended for security reasons.
WEP is an old encryption and may lead to setup and streaming problems.
Refer to the user guide of your router to select the encryption method.
To Next Page
Loading...
Need help?
General
