Keithley 2000 Calibration Manual

Optimizing measurement accuracy
The configurations listed below assume that the multimeter has had factory setups restored.
DC voltage, DC current, and resistance:
• Select 6 ½ digits, 10 PLC, filter ON (up to 100 readings), fixed range.
• Use REL on DC voltage and 2-wire resistance measurements.
• Use 4-wire resistance measurements for best accuracy.
AC voltage and AC current:
• Select 6 ½ digits, 10 PLC, filter ON (up to 100 readings), fixed range.
Temperature:
• Select 6 ½ digits, 10 PLC, filter ON (up to 100 readings).
A-10 Specifications

Keithley 2000 Specifications

General

Digits	6.5
DC Voltage Range	100 mV to 1000 V
AC Voltage Range	100 mV to 750 V
Resistance Range	100 Ω to 100 MΩ
Connectivity	IEEE-488 (GPIB)
Display Type	VFD