EasyManuals Logo

Keithley 617 User Manual

Keithley 617
183 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #74 background imageLoading...
Page #74 background image
Table 3-11. Device-Dependent Command Summary (Cont.)
Mode
3ata Format
Trigger Mode
SRQ
EOI and Bus Hold Off
Terminator
Status Word
3.10.3 Range (RI
-r-
,
Command
GO
Gl
G2
TO
Tl
M
T3
T4
15
T6
T7
MO
Ml
M2
M8
Ml6
M32
KO
Kl
K2
K3
YfLF CR)
YICR LF)
YIASCII)
YX
IJO
Ul
u2
Description
Reading with Prefix (NDCV - 1.23456E+OO)
Reading without Prefix f - 1.23456E+OO)
Reading with Prefix and Buffer Suffix (if in Bl)
(NDCV-1.23456E+OO, 012)
Continuous, Trigger by Talk
One-Shot, Trigger by Talk
Continuous, Trigger by GET
One-Shot. Trigger by GET
Continuous, Trigger by X
One-Shot, Trigger by X
Continuous, Trigger by External Trigger
One-Shot, Trigger by External Trigger
Disable SRQ
Reading Overflow
Buffer Full
Reading Done
Ready
Error
Enable EOI and Bus Hold-off On X
Disable EOI, Enable Bus Hold-off On X
Enable EOI, Disable Bus Hold-off On X
Disable both EOI and Bus Hold-off On X
Terminator = LF CR
Terminator = CR LF
Terminator = ASCII Character
No Terminator
Send Status Format: 617 FRRCZNTOBGDQMMKYY
Error Conditions
Data Conditions
Paragraph
3.10.13
3.10.14
3.10.15
3.10.16
3.10.17
3.10.18
HP-85 Programming Example-Make sure the instrument
is in the autorange mode and then enter the following
statements into the HP-85:
The range command gives the user control over the sensitivi-
ty of the instrument. This command, and its options, perform
REMOTE 727 (END LINE)
essentially the same functions as the front panel AUTO and
OUTPLJT 727;“R3X” (END LINE)
up and down range buttons. Range command parameters and
the respective ranges for each measuring function are sum-
When the END LINE key is pressed the second time, the in-
marized in Table 3-12. The instrument will be ready to take a
strument cancels the autorange mode, and enters the R3 range
reading after the range is set up when responding to a range
instead.
command.
Model 8573 Programming Example-Make sure the in-
Upon power up, or after receiving a DCL or SDC command,
strument is in the autorange mode. Now enter the following
the instrument will be in the RO (autorange) mode.
statements into the IBM-PC keyboard:
3-20

Table of Contents

Other manuals for Keithley 617

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keithley 617 and is the answer not in the manual?

Keithley 617 Specifications

General IconGeneral
BrandKeithley
Model617
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals