To Next Page

To Previous Page

List of Tables

1 Getting Started

Table 1-1 Main menu............................................................................................. 1-20

Table 1-2 Configuration menus ............................................................................. 1-21

Table 1-3 Default settings...................................................................................... 1-25

2 TSP Programming Fundamentals

Table 2-1 Example script to sweep V and measure I ............................................ 2-40

Table 2-2 Example script using a function............................................................. 2-41

Table 2-3 Example interactive chunk fragment for a script ................................... 2-42

3 DUT Test Connections

Table 3-1 Selecting the sense mode from the front panel....................................... 3-6

Table 3-2 Commands to select sense mode ........................................................... 3-7

Table 3-3 Commands to select Output-off state.................................................... 3-19

4 Basic Operation

Table 4-1 Source-measure capabilities ................................................................... 4-3

Table 4-2 Maximum compliance values .................................................................. 4-4

Table 4-3 Compliance commands........................................................................... 4-5

Table 4-4 Auto zero settings.................................................................................... 4-8

Table 4-5 Auto zero command and options............................................................. 4-9

Table 4-6 Trigger commands ................................................................................ 4-12

Table 4-7 Basic source-measure commands ........................................................ 4-15

Table 4-8 Basic contact check commands ............................................................ 4-25

5 Sweep Operation

Table 5-1 Logarithmic sweep points........................................................................ 5-6

Table 5-2 Staircase sweep functions....................................................................... 5-9

Table 5-3 Pulse sweep functions........................................................................... 5-10

Table 5-4 Custom sweep functions ....................................................................... 5-10

Table 5-5 Sweep example parameters.................................................................. 5-11

6 Range, Digits, Speed, Rel, and Filters

Table 6-1 Source and measurement ranges ........................................................... 6-2

Table 6-2 Range commands ................................................................................... 6-6

Table 6-3 Digits commands..................................................................................... 6-8

Table 6-4 Speed command ..................................................................................... 6-9

Table 6-5 Rel commands ...................................................................................... 6-11

Table 6-6 Filter commands.................................................................................... 6-15

Keithley SourceMeter 2612 Reference Manual

Other manuals for Keithley SourceMeter 2612