Flexlite GX
Operating manual - EN
2. At the wire feeder end of the cable, remove the wire liner's sleeve nut and retainer cone.
The GX series 8 welding gun has a long sleeve nut and the series 8 GMN, WS and 608W models include also an addi-
tional sealing ring (*). Remove that also.
3. Remove the old wire liner from the cable hose.
If you still plan to use the same wire liner later, make sure not to damage the wire liner at this stage.
© Kemppi
13
1921390 / 2310
To Next Page
Loading...
