Need help?Do you have a question about the KENT SP500 and is the answer not in the manual?
Identifies and lists the main functional components of the SP500 printer.
Instructions for leveling the machine mechanically before operation.
Steps for connecting the main air supply and setting pneumatic pressure.
Guidance on connecting the main power cable and grounding the machine.
Explains the function of each button and display on the front control panel.
Detailed steps for powering on the machine and initial setup.
Configuration options for the one-cycle printing mode.
Configuration options for the automatic printing mode.
Instructions for initiating one-cycle and auto printing modes.
Procedures for safely stopping the machine using the foot or panic switch.
Describes the movement stages during the flat printing cycle.
Describes the movement stages during the round printing cycle.
Steps to set the worktable to the correct height for printing.
Guide on how to mount and position the printing screen.
Procedures for ensuring the screen is level for accurate prints.
Adjusting screen ends and angle using knobs and locking screws.
Instructions for installing and adjusting the squeegee for optimal ink transfer.
How to set the print tension using the tension knob.
Steps to mount and adjust the flooder for ink application.
Steps to adjust the flooder height using adjustment knobs.
Setting the carriage travel distance for proper print coverage.
How to add ink and clean the screen when it gets clogged.
Adjusting the worktable's position in and out relative to the print head.
Adjusting the tilt angle of the worktable for specific printing needs.
Adjusting the vertical height of the worktable.
To Next Page
General